Powertrafos

Power — Transformer size in KVA

Once the voltage is determined, the power required at peak load (heat-up) can be calculated by use of the following formula:


Power (KVA):
Voltage2

______________________

Total Resistance X 1000



Total Resistance:

Length of Band (cm) X
Band Resistance (Ohms/cm)

målskemaMaximum allowable KVA for RES-Controllers:
at 400 volt primary power supply is 8.0 KVA
at 230 volt primary power supply is 4.4 KVA
at 115 volt primary power supply is 2.2 KVA

Applications that require more power can be operated by use of a Booster System. Please look under "Accessories" or contact the JBE Application Engineering Staff for assistance.


The transformer’s secondary voltage selection is very important because the controller will go full “ON” when the controller is first activated. If the secondary voltage is too low, the ramp-up will be slow and the time required to reach the pre-set temperature will be too long. 

Alternatively, if the voltage is too high, the ramp-up rate may exceed 1°C/mSec. In this case, the controller will go into a switching mode, control will be unsatisfactory, and damage to the controller may result.

 

 

Search funktion only active from PC and not from smartphone

Please use Internet Explorer show all contents

By new search go back to Powertrafos

 

​      

 

   

        

 

Info & Contact

Jørgen Bork Electronic ApS

CVR: 25809858

Åvej 30A, Hareskovby

DK - 3500 Værløse

Telefon: +45 44 48 88 80

Fax.: + 45 44 48 88 60

(only online at office times)

Office time​

Monday - Thursday:

a.m. 8:00 - p.m. 16:00


Friday:

a.m. 8:00 - p.m. 15:00

E-mail

info@borkelectronic.dk
jb@borkelectronic.dk
faktura@borkelectronic.dk

_

YOU ARE WELCOME TO USE THIS FORM TO GET IN CONTACT WITH US

 
 
 
 
Nogle felter er ikke udfyldt korrekt